Fire Power HP Select Oil Filter – 841-9294

• Premium synthetic blend filter media
• Compatible with mineral and synthetic oils

Spin-on filter features:

– 100% leak tested prior to packaging

– 17mm removal nut, pre-drilled for safety wire

– Durable silicone anti-drain back valve (where applicable)

– Pre-lubed gasket

Features

• Media enhancement by M-Pleating, increases Dust Holding Capacity (D.H.C) and reduces pressure drop
• The zigzag pleating pattern provides more filtration area allowing more dust holding capacity (DHC)
• Additional filtration area gives the oil more room to flow, resulting in lower pressure drop
• The media is resin-impregnated to ensure structural integrity during its operation under pressure and temperature spikes
• Forming tapped thread for easy installation and spin-on
• Pre-lubricated gasket
• The gasket is lubed from the factory to aid installation
• The base plate is covered with shrink film to ensure that the lube stays there until the time of usage and dust protection
• Standard features plus the following:
• Heat-resistant Anti-Drainback valve (ADBV)
• Unlike standard nitrile rubber, silicone rubber has a higher heat-resistance
• The enhanced ADBV will prevent dry starts and provides durability throughout the extended life of the filter
• 17mm Hex Nut
• Easy for service and removal after prolonged usage
• The nut is designed for safety wire attachment if needed
• HARDDRIVE OIL FILTERS ARE “DECAL FREE” FOR CLEAN LOOK